ELECTRONICS

FCI Electronics

Manual Part No. 415988-001

Issued: Date (03/12/99)

Page 4 of 18

Rev. 05/07/01 ECR V10337

Revision B

K\DCU\Manuals

INTRODUCTION

Hand Tool Function

The HT-0095 is a manually operated hand tool designed for crimping loose piece (individual)

Mini PV™ terminals to various sizes of wire.

Physical Description

The major components, which make up the HT-0095, are identified in Figure 1. These

components include a frame, lever, tooling and tooling holders, and terminal holding pins. The

heart of the hand tool is the tooling. The tooling performs the crimping operation and is divided into

top and bottom component groups. The top group consists of those parts, which remain stationary

with the frame. The bottom group contains those parts, which move with the lever. The HT-0095 is

equipped with tooling for crimping two different ranges of wire sizes. These are identified as "A"

and "B" on a plate affixed to the hand tool frame. The "A" side tooling is for crimping terminals to

wire sizes ranging from 28-32 AWG. The "B" side tooling is used for wire sizes from 22-26 AWG.

Figure 1

PDM: Rev:B

Released

STATUS:

Printed: Dec 19, 2002