RHR61, RHR64

Radiations

5

Radiations

Total ionizing dose (MIL-STD-883 TM 1019)

The products guaranteed by radiation within the RHA QML-V system, fully comply with the

MIL-STD-883 TM 1019 specification.

The RHR61 and RHR64 are RHA QML-V tested and characterized in full compliance with

the MIL-STD-883 specification, condition B (between 10 and 100 mrad/s).

All parameters provided in Table 4, Table 5, and Table 6 apply to pre-irradiation, Table 7

and Table 8 apply to post-irradiation as follows:

•

All tests are performed in accordance with MIL-PRF-38535 and the test method 1019

of the MIL-STD-883 for total ionizing dose (TID).

•

The initial characterization is performed in qualification only on both biased and

unbiased parts.

•

Each wafer lot is tested in the worst bias case condition, based on the results obtained

during the initial qualification.

Heavy ions

The behavior of the product when submitted to heavy ions is not tested in production.

Heavy ion trials are performed on qualification lots only.

Table 9: Radiations

Type

Characteristics

Value

Unit

TID

Low-dose rate (36 to 360 rad/h) up to:

100

krad

Heavy ions

SEL immunity up to:

(with a particle angle of 60 ° at 125 °C)

120

MeV.cm²/mg

SEL immunity up to:

(with a particle angle of 0 ° at 125 °C)

60

SET immunity (at 25 °C)

Characterized

DocID027171 Rev 3

13/20