ESP-07S

DS-ESP07S-1

3.1. Package information

ESP-07S use a half hole patch package, Module PCB Footprint shown in the following figure:

Figure 5 Module PCB Footprint

3.2. OEM installation mathod

Using ESP-07S module Please reference in front of the package information in the Layout on the main

board for OEM factory. Please pay more attention Module's direction and the antenna close to the edge

of board is better, the Components and layout should not be on the bottom of antenna then soldering

the module. When the module be soldering cannot in the environment of high temperature. We

recommend the reflow soldering temperature curves is shown in figure 6:

Figure 6 Recommend reflow soldering temperature curves