STPM01FTR datasheet(49/56 Pages) STMICROELECTRONICS

部品番号	STPM01FTR

部品情報	Programmable single phase energy metering IC

PDF	56 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

49 / 56 page

STPM01

STPM01 Calibration

49/56

VDIV = (XV * VBG)/ (2 * GDIF * AV * Kv * GDF * GINT * BV)= 145,6 mV

Choosing R2=500

Ω (connected between VI and VSS), the R1 resistor (connected between

VLINE and VIP) value is obtained:

R1 = R2 * (Vn - VDIV) / VDIV = 789,3 Ω

Indicating with IA and VA the real readings on the STPM01 rms registers of voltage and

current, and with XI and XV ideal values of RMS current and voltage readings already

calculated, the final values for calibrators can be calculated as:

XV = (Kv * VA) / 0.875

XI = (Ki * IA) / 0.875

If the computed final calibration data would fall out of calibration data range, the Energy

Meter should be recognized as bad or the given presumptions and calculations above

should be checked. Otherwise, if the final data of calibrators would be written into Energy

Meter, the rms readings should be very close to target values I and V and the frequency of

LED output should be very close to target value f.

STPM01FTR データシート(PDF) 49 Page - STMicroelectronics