8 Power Supply Recommendations

The power supply can be any voltage between the minimum and maximum supply voltage rating located in the

Recommended Operating Conditions. Each VCC terminal should have a good bypass capacitor to prevent power

disturbance. A 0.1-μF capacitor is recommended for this device. It is acceptable to parallel multiple bypass caps

to reject different frequencies of noise. The 0.1-μF and 1-μF capacitors are commonly used in parallel. The

bypass capacitor should be installed as close to the power terminal as possible for best results.

9 Layout

9.1 Layout Guidelines

When using multiple-input and multiple-channel logic devices inputs must not ever be left floating. In many

cases, functions or parts of functions of digital logic devices are unused; for example, when only two inputs of a

triple-input AND gate are used or only 3 of the 4 buffer gates are used. Such unused input pins must not be left

unconnected because the undefined voltages at the outside connections result in undefined operational states.

All unused inputs of digital logic devices must be connected to a logic high or logic low voltage, as defined by the

input voltage specifications, to prevent them from floating. The logic level that must be applied to any particular

unused input depends on the function of the device. Generally, the inputs are tied to GND or VCC, whichever

makes more sense for the logic function or is more convenient.

SN54HC166, SN74HC166

SCLS117E – DECEMBER 1982 – REVISED FEBRUARY 2022

www.ti.com

10

Submit Document Feedback

Copyright © 2022 Texas Instruments Incorporated

Product Folder Links: SN54HC166 SN74HC166