L9680 datasheet(13/286 Pages) STMICROELECTRONICS

13 / 286 page

DS11615 Rev 7

13/286

L9680

Description

285

Description

The L9680 is a chip that can be used in advanced airbag systems for mature airbag markets

or in cut-off battery systems for integrated safety markets. This device is family compatible

with the L9678 and L9679 devices. Safety system integration is enabled through higher

power supply currents and integrated active wheel speed sensor interface. The active wheel

speed interface is shared with the PSI-5 satellite interface to create a generic remote safety

sensor interface compliant to both systems.

High frequency power supply design allows further cost reduction by using smaller and less

expensive external components. All switching regulators operate at 1.882 MHz while buck

converters have integrated synchronous rectifiers.

Additional attention is given to system integrity and diagnostics. The ER capacitor is

electrically isolated from the boost regulator by a fixed charge current circuit to control in-

rush current. An additional discharge current circuit is integrated in the IC to measure the

capacitance and the ESR of ER capacitor. The same current sources can be used to

discharge the capacitor at shutdown.

Thanks to low quiescent current, the device can be directly connected to battery. In this way,

the device start-up and shutdown are controlled through the wake-up input function. The

power supply and crossover function are controlled automatically through the internal state

machine.

The user can select both ECU logic voltage (VCC at 3.3 V or 5.0 V) and energy reserve

output voltage (at either 23 V or 33 V). Deployment voltage is set to a maximum of 25 V for

all profiles and can be controlled through external safing switch circuit using the high-side

safing switch reference enabled through the system SPI interface or the arming logic.

L9680 データシート(PDF) 13 Page - STMicroelectronics