Environmental Sensors Evaluation Kit Manual

R36UH0011EU0103 Rev.1.03

Jul 30, 2024

Page 7

2.

Usage Guide

After starting the ES-Eval software, the initial window is displayed as shown in Figure 4. The initial display in all

operation modes consists of the following blocks:

■

Measurement Control

■

Sensor Select

■

Algorithm Select & Configuration

■

Signal Analysis

■

Plot Control

■

Plot Visualization

Note: The ES-EVAL automatically checks upon start if an ESCom firmware update is available. It is

recommended to always use the latest firmware for the Communication Board, which can be installed by using

the latest ES-EVAL.

Figure 4. Initial Display during Measurement (Exemplary for ZMOD4410 and HS4001)