21

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

If you have any problems which cannot be resolved by reference to the

above, or if you require spare parts for your welder please contact your

local Clarke dealer.

Erratic wire feed. Tensioning Knob too tight.

Loosen tensioning knob slightly.

Tension roller worn.

Check and replace if necessary.

Insufficient pressure on tension

roller.

Increase pressure on tension roller

Caution: Do not over-tighten.

Wire dirty, rusty, damp or bent. Re-cut wire and ensure it is clean.

Liner partially blocked.

Clean with compressed air.

Poor quality

welds.

Rusty, painted, damp, oil or

greasy workpiece.

Ensure workpiece is clean and dry.

Rusty/dirty wire.

Ensure wire is clean and dry.

Poor earth contact.

Check earth clamp/workpiece

connection.

Welder cuts out

whilst in use.

Duty cycle exceeded (auto cut-

out operates).

Allow welder to cool 15-30 mins

before continuing.

Note: If duty cycle is continually

exceeded, damage to the welder

may result and welder output is

probably too small for application.

PROBLEM

CAUSE

SOLUTION