13

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

THE CONTROL PANEL

1. Wire speed control knob. As a general rule, a higher current requires a

higher wire speed.

2. Current setting switches MIN-MAX & 1-2. Used together, these two switches

provide 4 increasing power levels as follows:

•MIN-1

•MIN-2

•MAX-1

•MAX-2

3. Power ON/OFF switch. When the power is ON the green switch will be

illuminated. When the welder is no longer required, the Power On/Off switch

should be switched to the OFF position and the plug should be disconnected

from the mains supply.

4. Thermal overload light. If the duty cycle is exceeded as a result of welding

for too long with a high current, the overload light will illuminate and the

welder will turn off. When the welder has cooled down (approx. 5 to 10

minutes), the power will be restored and welding can recommence.