NRF24L01P-R7 datasheet(21/78 Pages) NORDIC

21 / 78 page

Revision 1.0

Page 21 of 78

nRF24L01+ Product Specification

Radio Control

This chapter describes the nRF24L01+ radio transceiver’s operating modes and the parameters used to

control the radio.

The nRF24L01+ has a built-in state machine that controls the transitions between the chip’s operating

modes. The state machine takes input from user defined register values and internal signals.

6.1

Operational Modes

You can configure the nRF24L01+ in power down, standby, RX or TX mode. This section describes these

modes in detail.

6.1.1

State diagram

The state diagram in Figure 4. shows the operating modes and how they function. There are three types of

distinct states highlighted in the state diagram:

•

Recommended operating mode: is a recommended state used during normal operation.

•

Possible operating mode: is a possible operating state, but is not used during normal operation.

•

Transition state: is a time limited state used during start up of the oscillator and settling of the PLL.

When the VDD reaches 1.9V or higher nRF24L01+ enters the Power on reset state where it remains in

reset until entering the Power Down mode.

NRF24L01P-R7 データシート(PDF) 21 Page - Nordic Semiconductor