X24164

4

Stop Condition

All communications must be terminated by a stop con-

dition, which is a LOW to HIGH transition of SDA when

SCL is HIGH. The stop condition is also used to place

the device into the standby power mode after a read

sequence. A stop condition can only be issued after the

transmitting device has released the bus.

Acknowledge

Acknowledge is a software convention used to indicate

successful data transfer. The transmitting device, either

master or slave, will release the bus after transmitting

eight bits. During the ninth clock cycle the receiver will

pull the SDA line LOW to acknowledge that it received

the eight bits of data. Refer to Figure 3.

The X24164 will respond with an acknowledge after

recognition of a start condition and its slave address. If

both the device and a write operation have been se-

lected, the X24164 will respond with an acknowledge

after the receipt of each subsequent eight bit word.

In the read mode the X24164 will transmit eight bits of

data, release the SDA line and monitor the line for an

acknowledge. If an acknowledge is detected and no

stop condition is generated by the master, the X24164

will continue to transmit data. If an acknowledge is not

detected, the X24164 will terminate further data trans-

missions. The master must then issue a stop condition

to return the X24164 to the standby power mode and

place the device into a known state.

Figure 3. Acknowledge Response From Receiver

3846 FHD F09

SCL FROM

MASTER

DATA

OUTPUT

FROM

TRANSMITTER

1

89

DATA

OUTPUT

FROM

RECEIVER

START

ACKNOWLEDGE