CS49310 datasheet(59/90 Pages) CIRRUS

59 / 90 page

CS49300 Family DSP

DS339F7

Figure 36. Autoboot Sequence

Notes: 1. RESET must be held LOWTrstl.

2. The RD and WR pins must be configured to select a

serial communication mode as defined in the

CS493XX Datasheet. The setup (Trstsu) and hold

(Trsthld) times must be observed for the RD, WR, and

AUTOBOOT pins.

3. INTREQ should be ignored during this period. 200 ms

is typical but this time is application code specific and

may be higher. Wait times should be verified by the

designer.

4. The READ_* and WRITE_* functions are

placeholders for the READ_I2C/READ_SPI and

WRITE_I2C/WRITE_SPI functions defined in Section

6.1, “Serial Communication” on page 36.

CORRECT VALUE?

READ_*(VARIABLE)

RESET(LOW) (NOTE 1)

RESET(HIGH) (NOTE 2)

RELEASE ABOOT

(NOTE 4)

WAIT 5 MS

AUTOBOOT COMPLETE

WRITE_*(HW_CONFIG_MSG,

HW_MSG_SIZE)

(NOTE 4)

WRITE_*(SW_CONFIG_MSG,

SW_MSG_SIZE)

(NOTE 4)

ABOOT(LOW)

WAIT 200 MS (NOTE 3)

WRITE_*(KICKSTART,

MSG_SIZE)

(NOTE 4)

CS49310 データシート(PDF) 59 Page - Cirrus Logic

CS49310 データシート(HTML) 59 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

データシートダウンロード

リンク URL

CS49310 データシート(PDF) 59 Page - Cirrus Logic

CS49310 データシート(HTML) 59 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

データシート ダウンロード

リンク URL

データシートダウンロード