VN771K datasheet(23/33 Pages) STMICROELECTRONICS

部品番号	VN771K

部品情報	Quad smart power solid state relay for complete H-bridge configurations

PDF	33 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

23 / 33 page

VN771K

Application recommendations

Doc ID 12534 Rev 4

23/33

Application recommendations

Figure 44. Application diagram bridge drivers

Most motor bridge drivers use a reverse battery protection diode (D) inside the supply rail.

This diode prevents a reverse current flow back to VBATT in case the bridge becomes

disabled via the logic inputs while motor inductance still carries energy. In order to prevent a

hazardous overvoltage at circuit supply terminal (VCC), a blocking capacitor (C) is needed to

limit the voltage overshoot. As basic orientation, 50µF per 1A load current is recommended.

As an alternative, a Zener protection (Z) is also suitable.

Even if a reverse polarity diode is not present, it is recommended to use a capacitor or

Zener at VCC because a similar problem appears in case the supply terminal of the module

has intermittent electrical contact to the battery or gets disconnected while the motor is

operating.

VN771K データシート(PDF) 23 Page - STMicroelectronics