UM0313

EK302DL GUI installation

7/33

2

EK302DL GUI installation

The installation of the Graphical User Interface (GUI) for the EK302DL requires two steps:

1.

installation on the PC of the software delivered with the evaluation kit.

2.

installation of the Virtual COM driver needed to use the evaluation kit board.

2.1

PC system requirements

Both the hardware and software that compose the EK302DL Evaluation Kit have been

2.2

Software installation

To install the software distributed with the EK302DL Evaluation Kit:

1.

insert the mini CD into the CD-ROM drive;

2.

if the “Autorun” screen does not appear, click on Start > Run, then enter

“D:\Autorun.exe” and click OK. “D” represents the letter of your CD-ROM drive;

3.

click on “Evaluation Kit SW Installation” from the “EK302DL Evaluation Kit” page;

4.

follow the on screen instructions (Figure 4).

Figure 4.

Software installation

2.3

Hardware installation

To install the virtual COM driver, insert the evaluation kit board into a free USB port. The

“Notify” icon should appear as in Figure 5.