AN4013 datasheet(20/37 Pages) STMICROELECTRONICS

20 / 37 page

General-purpose timer modes

AN4013

20/37

DocID022500 Rev 4

The following figure presents an example of the Retriggerable OPM mode

Figure 3. Retriggerable OPM mode

To configure the timer in this mode:

Configure the input pin and mode:

Select the TIxFPx trigger to be used by writing CCxS bits in CCMRx register.

Select the polarity of the input pin by writing CCxP and CCxNP bits in CCER

Configure the TIxFPx trigger for the slave mode trigger by writing TS bits in SMCR

Select the Combined Reset + trigger mode for the slave mode by writing SMS =

1000 in SMCR register.

Configure the output pin and mode:

Select the output polarity by writing CCyP bit in CCER register.

Select the output compare mode by writing OCyM bits in CCMRy register

(Retriggerable OPM mode 1 or Retriggerable OPM mode 2).

Set the Pulse length value by writing in CCRy register if the counter is down-

counting or by writing in the ARR if the counter is up-counting.

For more details on using the timer in this mode, refer to the examples provided in the

STM32F30x standard peripheral libraries, in the

/Project/STM32F30x_StdPeriph_Examples/ TIM/Retriggerable OPM folder.

AN4013 データシート(PDF) 20 Page - STMicroelectronics