LSM6DS3HTR datasheet(29/104 Pages) STMICROELECTRONICS

29 / 104 page

DocID028370 Rev 4

29/104

LSM6DS3H

Functionality

104

Functionality

5.1

Operating modes

The LSM6DS3H has three operating modes available:

 only accelerometer active and gyroscope in power-down

 only gyroscope active and accelerometer in power-down

 both accelerometer and gyroscope sensors active with independent ODR

The accelerometer is activated from power down by writing ODR_XL[3:0] in CTRL1_XL

(10h) while the gyroscope is activated from power-down by writing ODR_G[3:0] in

CTRL2_G (11h). For combo mode the ODRs are totally independent.

5.2

Gyroscope power modes

In the LSM6DS3H, the gyroscope can be configured in four different operating modes:

power-down, low-power, normal mode and high-performance mode. The operating mode

selected depends on the value of the G_HM_MODE bit in CTRL7_G (16h). If G_HM_MODE

is set to ‘0’, high-performance mode is valid for all ODRs (from 12.5 Hz up to 1.6 kHz).

To enable the low-power and normal mode, the G_HM_MODE bit has to be set to ‘1’. Low-

power mode is available for lower ODR (12.5, 26, 52 Hz) while normal mode is available for

ODRs equal to 104 and 208 Hz.

5.3

Accelerometer power modes

In the LSM6DS3H, the accelerometer can be configured in four different operating modes:

power-down, low-power, normal mode and high-performance mode. The operating mode

selected depends on the value of the XL_HM_MODE bit in CTRL6_C (15h). If

XL_HM_MODE is set to ‘0’, high-performance mode is valid for all ODRs (from 12.5 Hz up

to 6.66 kHz).

To enable the low-power and normal mode, the XL_HM_MODE bit has to be set to ‘1’. Low-

power mode is available for lower ODRs (12.5, 26, 52 Hz) while normal mode is available

for ODRs equal to 104 and 208 Hz.

LSM6DS3HTR データシート(PDF) 29 Page - STMicroelectronics