EMC2103 datasheet(30/85 Pages) MICROCHIP

部品番号	EMC2103

部品情報	RPM-Based Fan Controller with Hardware Thermal Shutdown

PDF	85 Pages

Scroll/Zoom	100%

メーカー	MICROCHIP [Microchip Technology]

ホームページ	http://www.microchip.com

Logo

30 / 85 page

RPM-Based Fan Controller with Hardware Thermal Shutdown

Datasheet

 2013 Microchip Technology Inc.

DS0005250A-page 30

5.5.1

Programming the RPM Based Fan Speed Control Algorithm

The RPM based Fan Speed Control Algorithm powers-up disabled. The following registers control the

algorithm. The EMC2103 fan control registers are pre-loaded with defaults that will work for a wide

variety of fans so only the TACH Target Register is required to set a fan speed. The other fan control

registers can be used to fine-tune the algorithm behavior based on application requirements.

Note that steps 1 - 7 are optional and need only be performed if the default settings do not provide

the desired fan response.

1. Set the Valid TACH Count Register to maximum number of tach counts to indicate the fan is

spinning.

2. Set the Spin Up Configuration Register to the Spin Up Level and Spin Time desired.

3. Set the Fan Step Register to the desired step size.

Figure 5.4 RPM based Fan Speed Control Algorithm

EMC2103 データシート(PDF) 30 Page - Microchip Technology