UM1900

Getting started

DocID027905 Rev 3

5/19

1

Getting started

This section describes the hardware requirements for the X-NUCLEO-CCA02M1

evaluation board.

1.1

Hardware requirements

The X-NUCLEO-CCA02M1 is an expansion board for use with STM32 Nucleo boards

(refer to UM1724 on www.st.com for further information).

The STM32 Nucleo board must be connected to the X-NUCLEO-CCA02M1 board, as

shown in Figure 2: "X-NUCLEO-CCA02M1 on STM32 Nucleo board".

Figure 2: X-NUCLEO-CCA02M1 on STM32 Nucleo board

The connection between the STM32 Nucleo and the X-NUCLEO-CCA02M1 is designed for

use with any STM32 Nucleo board. When mounting the X-NUCLEO-CCA02M1 on the

STM32 Nucleo, ensure that all the pins are aligned with their corresponding connector. It is

very important to handle both boards carefully during this operation to avoid damaging or

bending the male/female pins and connectors.

ESD prevention measures must also be implemented to avoid damaging any X-NUCLEO-

CCA02M1 board components.