서식 Rev : 00

문서명 : 제품개발(UV PKG) 절차서

www.seoulviosys.com

– Avoid leaving fingerprints on silicone resin parts.

– Silicone resin will attract dust so use covered containers for storage.

– When populating boards in SMT production, there are basically no restrictions regarding

the form of the pick and place nozzle, except that excessive mechanical pressure on the

surface of the resin must be prevented.

– It is not recommend to cover the silicone resin of the LEDs with other resin (epoxy,

urethane, etc).

3) Safety for eyes and skin

•

The Products emit high intensity ultraviolet light which can make your eyes and skin harmful,

So do not look directly into the UV light and wear protective equipment during operation.

4) Cleaning

•

This device is not allowed to be used in any type of fluid such as water, oil, organic solvent ,

etc.

5) Others

•

The appearance and specifications of the product may be modified for improvement without

notice.

•

When the LEDs are in operation the maximum current should be decided after measuring the

package temperature.

•

The driving circuit must be designed to allow forward voltage only when it is ON or OFF. If the

reverse voltage is applied to LED, migration can be generated resulting in LED damage.

•

Do not handle this product with acid or sulfur material in sealed space.