LP2 datasheet(5/27 Pages) EATON

部品番号	LP2

部品情報	Single Row Terminal Blocks

PDF	27 Pages

Scroll/Zoom	100%

メーカー	EATON [Eaton All Rights Reserved.]

ホームページ	https://www.eaton.com

Logo

5 / 27 page

EATON www.eaton.com

Mounting Plates

Options MP & MT

MP Metal inserts with 0.150” (3.8) dia. hole accept #6 screw.

MT Metal inserts with tapped hole accept #6-32 screw.

Bulk part numbers 1MP-J & 1MT-J.

Right Angle Bends (A1 only)

Right angle terminals are offered on the A1. Configurations are defined

in these dimensions: X = pin extension beyond the block base; Z =

length from block base to centerline of the terminal tip. Standard bends

consist of the X and Z dimensions shown in the chart. Specify by adding

the R26 Bend Option Code to the terminal part number.

Bend Option Code

R26 (04 terminal only)

0.14 (3.5)

0.09 (2.3)

Dimensions: in (mm)

Right Angle Bends (A1 only)

(Dimensions in inches)

Option DR

Counterbored holes across mount ends of block enable fastening

with two screws at right angles to normal mount position.

Mounting Options

Single RowTerminal Blocks

LP2 データシート(PDF) 5 Page - Eaton All Rights Reserved.