STE2007 datasheet(17/62 Pages) STMICROELECTRONICS

17 / 62 page

STE2007

4 INTERFACE

17/62

Figure 6.

3-lines SPI Data Transfer break condition

4.1.1.2 Data/Command Transfer pause

It is possible while transferring Frame Memory Data, Commands or Command Parameters to

insert a pause in the data transmission (!CS Line HIGH after 8 Bits Received). When !CS is

forced high after a whole byte received, the received byte is processed. Then STE2007 is

forced in a wait state ready to restart processing incoming data from the point where the

communication has been paused

If a new command identifier is transferred after a pause condition the previous communication

session is definitively closed.

Four are the possible conditions:

–

Command-Pause-Command

–

Command-Pause-Parameter

–

Parameter-Pause-Command

–

Parameter-Pause-Parameter

Figure 7.

3-lines SPI Data Transfer Pause

4.1.2

Driver TxData Mode (Read Mode)

The Driver TxData–mode is a method to check the electrical interconnection between LCD

driver and baseband, to identify the driver and for VDD Intercfonnection electrical self testing.

LR0204

!CS

SDA

SCL

COMMAND/PARAMETER

Break

D/!C

LR0203

!CS

SDA

SCL

COMMAND/PARAMETER

Pause

D/!C

STE2007 データシート(PDF) 17 Page - STMicroelectronics

STE2007 データシート(HTML) 17 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

データシートダウンロード