ST72340 datasheet(31/191 Pages) STMICROELECTRONICS

31 / 191 page

ST72340, ST72344, ST72345

31/191

7.4 RESET SEQUENCE MANAGER (RSM)

7.4.1 Introduction

The reset sequence manager includes three RE-

SET sources as shown in Figure 16:

■ External RESET source pulse

■ Internal LVD RESET (Low Voltage Detection)

■ Internal WATCHDOG RESET

Note: A reset can also be triggered following the

detection of an illegal opcode or prebyte code. Re-

fer to Section 12.2.1 on page 149 for further de-

tails.

These sources act on the RESET pin and it is al-

ways kept low during the delay phase.

The RESET service routine vector is fixed at ad-

dresses FFFEh-FFFFh in the ST7 memory map.

The basic RESET sequence consists of 3 phases

as shown in Figure 15:

■ Active Phase depending on the RESET source

■ 256 or 4096 CPU clock cycle delay (selected by

option byte)

■ RESET vector fetch

The 256 or 4096 CPU clock cycle delay allows the

oscillator to stabilise and ensures that recovery

has taken place from the Reset state. The shorter

or longer clock cycle delay should be selected by

option byte to correspond to the stabilization time

of the external oscillator used in the application

(see Section 15.1 on page 181).

The RESET vector fetch phase duration is 2 clock

cycles.

Figure 15. RESET Sequence Phases

7.4.2 Asynchronous External RESET pin

The RESET pin is both an input and an open-drain

output with integrated RON weak pull-up resistor.

This pull-up has no fixed value but varies in ac-

cordance with the input voltage. It can be pulled

low by external circuitry to reset the device. See

“ELECTRICAL

CHARACTERISTICS”

page 152 for more details.

A RESET signal originating from an external

source must have a duration of at least th(RSTL)in in

order to be recognized (see Figure 17). This de-

tection is asynchronous and therefore the MCU

can enter reset state even in HALT mode.

Figure 16. Reset Block Diagram

RESET

Active Phase

INTERNAL RESET

256 or 4096 CLOCK CYCLES

FETCH

VECTOR

RESET

RON

VDD

WATCHDOG RESET

LVD RESET

INTERNAL

RESET

PULSE

GENERATOR

Filter

ILLEGAL OPCODE RESET 1)

Note 1: See “Illegal Opcode Reset” on page 149. for more details on illegal opcode reset conditions.

ST72340 データシート(PDF) 31 Page - STMicroelectronics

ST72340 データシート(HTML) 31 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

データシートダウンロード

リンク URL

ST72340 データシート(PDF) 31 Page - STMicroelectronics

ST72340 データシート(HTML) 31 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

データシート ダウンロード

リンク URL

データシートダウンロード