www.sensata.com

Page 9

Copyright © 2022 Sensata Technologies, Inc.

ORDERING OPTIONS -

NORTH AMERICAN LP35 MODELS

INCREMENTAL

See standard resolution list, ex: 01024

ABSOLUTE

See standard resolution list, ex: 12

Mounting

Standard Outputs

Output Termination Type

Coupling / Tether Types

Special Features

XXXXX Example shows H30S for Metric and H4EP for Imperial

H:Through Hollow Shaft (Includes collet clamp)

30S = 30mm (Non isolated)

Less than 30mm with isolated reduction sleeve

H4EP = ½”

H5EP = ”

H6EP = ¾”

H7EP = ”

H8EP = 1”

H8ES = 1” no isolation

B: Blind Hollow Shaft (Screws into mating shaft – screw provided)

Non isolated versions standard. Isolated versions <30mm

available, consult factory.

B30S = 30 mm

B4ES = ½”

B5ES = ”

B6ES = ¾”

B7ES = ”

B8ES = 1”

C: Hollow Shaft with Integrated Coupling

(all options insulated)

C14P = 14 mm

C20P = 20 mm

C4EP = ½”

C6EP = ¾”

S: Shafted (Requires separate coupling)

S12 = 12mm

S3E = ”

INCREMENTAL

28/V = Standard line driver 5-30V In / Out / PushPull

28/5 = Standard Line Driver with 5 volt (TTL) regulated

output

28/VR = Push Pull 11-30V reinforced (only T version)

Note: All versions are short-circuit protected. Reinforced

electronics are short circuit and overvoltage protected

ABSOLUTE

28/SI:

SSI RS485 w/o parity

28/SR:

SSI RS485 reinforced w/o parity

Terminal Box version only

S VERSION

T0 = No tether = STD

T2 = Long Tether Kit (56C)

T3 = Short Tether Kit

BOX VERSION

T4 = Standard Fork is provided for all LP35-TB with blind or through hollow shaft

T5 = M9445/059-02 Standard Fork + 56C Face hardware

Other Tether arms may be ordered separately (Ex: Ball joint Tether M9230-04/XXX) consult with factory

Family

LP35

HN

Housing Type

Output

Resolution

LP35: Low Profile

90mm (3.5”) body size

HN = Hazardous Area, Non-Incendive

INCREMENTAL ABZC

Q28 = Index with A&B High

Q29 = Index gated with Neg B

ABSOLUTE

AB = Natural Binary

AG = Gray Code

Use this diagram, working from left to right to construct your model number

(Example : LP35-HN-Q28-02048-H30S-28/V-SG060- T0)

NOTE: (1)“T” Code changes the form from approximately 90mm (3.5”) round to a rectangle that is approximately 128mm (5”) high by 116mm wide (4.5”)

BOX

T= Terminal Box with cable gland.(1)

STANDARD CABLE

SGXXX = Cable gland seal. PVC jacket and US standard

color code.

SQPHHH = Polyurethane with EU Color Code (Not UL

listed);

STEHHH= Silicone with EU color code (Not UL listed);

XXX=cable length in inches up to 120” in 6 inch increments;

HHH = cable length in dm up to 100 dm in 5 dm increments

CONNECTOR

SM12 : European standard connector with EU color code

SG18C18: US- MS3102R18-1P on end of 18” cable

SGS18C12: US- MS3112E12-10P on end of 18” cable