10

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

MAINTENANCE

After use clean out any accumulated dust etc. Keep the cooling vents clear. If the

sander should become too hot, run it for 2 minutes without load.

Clean the housing with a soft cloth. Any worn or damaged parts should be replaced by

qualified personnel. Keep the handles clean and free from oil and grease. Refer to

qualified service personnel if internal maintenance is required.

Always store the belt sander in the carrying case.

CHANGING THE CARBON BRUSHES

1. With a suitable screwdriver, remove the carbon brush caps on either side of the

belt sander.

2. Remove the carbon brush/spring assembly.

3. If the carbon brushes are worn down to 4mm, or less, replace them with the new

brushes (1 spare set supplied).

4. Replace the carbon brush caps and tighten them.

NOTE: Both brushes must be replaced at the same time.

GENERAL CARE

Your sander has been designed to operate over a long period of time with a minimum

of maintenance. Continuous satisfactory operation depends upon proper care.

• Regularly clean the ventilation slots using a soft dry brush or dry cloth.

WARNING: MAKE SURE THAT THE BELT SANDER IS SWITCHED OFF

AND DISCONNECTED FROM THE MAINS SUPPLY BEFORE STARTING

ANY CLEANING OR MAINTENANCE PROCEDURES.