11

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

• Only clean the motor housing using a clean damp cloth. Do not use any

abrasive or solvent-based cleaner.

• A damaged power cable should be replaced by your Clarke dealer or a

qualified electrician.

• The bearings in this sander are sealed for life and require no maintenance.

TROUBLESHOOTING

SANDER IS OVERHEATING

This indicates the machine is dirty. Clean the ventilation holes, and blow out with

compressed air or clean with a dry cloth.

Overloading the machine will also cause overheating. Do not apply excessive

pressure.

EXCESSIVE SPARKING OCCURS

This indicates worn brushes. This problem is quickly remedied but you should consult

your CLARKE dealer for parts and advice.

SANDER DOES NOT OPERATE WHEN SWITCHED ON

Check to ensure the fuse is sound and replace if necessary. If the fuse is sound or

blows repeatedly, consult your CLARKE dealer.

THE DUST IS NOT EXTRACTED

Dust bag is full (empty waste bag), dust extractor flue is blocked, this is usually

caused by allowing bag to become too full, (remove and empty bag, also clear

blockage).

ACCESSORIES

A wide range of accessories is available from your nearest CLARKE dealer, for further

information, contact your nearest dealer, or telephone CLARKE International Sales

department on 01992 565300.