A22Z-R25 datasheet(26/30 Pages) OMRON

26 / 30 page

A22

Square Pushbutton/Indicator

• Square Pushbutton/Indicator

Insert the protruding tip of the Cap Puller (A3PJ-5080) into the Cap

slot, hold the plate spring, and pull them to remove the Color Cap.

• Mounting the Color Cap:

Mount the Color Cap on the flange and firmly push the Color Cap.

When the Color Cap is inserted, check whether it operates properly.

When replacing the Lamp, remove the Color Cap and diffusion

plate with fingers or Cap Puller.

Attach the Character Film properly so that it fits inside the

protruding part of the diffusion plate. Then, match the diffusion plate

to the square flange and insert the Cap.

Emergency Stop Switch

• Insert the protrusion of the Tightening Wrench (A22Z-3905) into the

Cap slot and then turn to remove the Cap.

Installing/Replacing the Lamp

Installing/Replacing from the Panel Surface

• Insert the Lamp Extractor (A22Z-3901) into the lamp, then rotate

the Extractor while pressing it.

Installing/Replacing on the Switch

• Grip the lamp with your fingers, then rotate the lamp while pressing

it against the Switch.

Control Box (Enclosure)

Mounting the Switch

The Standard-size Legend Plate Frame can be mounted. Mount the

Frame as shown in the following diagram. Mount the Switch in the

same way as for an ordinary panel.

Creating a Cable Port Hole

Place the tip of a screwdriver on the surface where the cable port hole

is to be created with the cover attached and strike the screwdriver with

a hammer to punch four holes.

Plate spring

Flange

Diffusion plate

Character Film

Color Cap

Snap-in Legend Plate

Switch box

Screwdriver

Groove

Side

Make four holes

in diagonal lines.

Cover

Cable port hole

A22Z-R25 データシート(PDF) 26 Page - Omron Electronics LLC

A22Z-R25 データシート(HTML) 26 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

データシートダウンロード