TDA7580 datasheet(31/39 Pages) STMICROELECTRONICS

31 / 39 page

TDA7580

Functional description

31/39

system is the shift register and the read data buffer. The system is single buffered in the

transfer direction and double buffered in the receive direction.

8.8

High speed serial synchronous interface (HS3I)

The high speed serial synchronous interface is a module to send and receive data at high

rate (up to 9.25Mbit/s per channel) in order to exchange data between 2 separate TDA7580

chip.

The exchanged data are related to signals that are used to increase reception quality in car

radio systems, which make use of antenna diversity based upon two separate antenna and

tuner sections.

The channel synchronization clock has a programmable duty cycle, so to reduce in band

harmonics noise.

8.9

Tuner AGC keying DAC (KEYDAC)

This DAC provides the front-end tuner with an analogue signal to be used to control the

automatic gain controlled stage, thus giving all time the best voltage dynamic range at the

IFADC input.

8.10

Asynchronous sample rate converter (ASRC)

This hardware module provides a very flexible way to adapt the internal audio rate, to the

one of an external source. It does not require further work off the DSP.

There is no need to explicitly configure the input and the output sample rates, as the ASRC

solves this problem with an automatic digital ratio locked loop.

Main features are:

●

Automatic tracking of sample frequency

●

Fully digital ratio locked loop

●

Sampling clock jitter rejection

●

Up conversion up to 1:2 Ratio

●

Linear phase

8.11

IF band pass

Σ Δ analogue to digital converter (IFADC)

The IFADC is a band pass Sigma Delta A to D converter with sampling rate of 37.05MHz

(nominal) and notch frequency of 10.7MHz. The structure is a second order switched

capacitor multi bit modulator with self calibration algorithm to adjust the notch frequency.

The differential ended input allows 4.0Vpp voltage dynamic range, and reduces the inferred

noise back to the previous stage (tuner), and in turn gives high rejection to common mode

noises.

The high linearity (very high IMD) is needed to fulfill good response of the channel

equalization algorithm.

Low thermal and 1/f noise assures high dynamic range.

TDA7580 データシート(PDF) 31 Page - STMicroelectronics

TDA7580 データシート(HTML) 31 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

データシートダウンロード