H8S2245 datasheet(247/818 Pages) RENESAS

247 / 818 page

Section 7 Data Transfer Controller

Rev.3.00 Mar. 26, 2007 Page 205 of 772

REJ09B0355-0300

(2) Software Activation

The second example shows how the DTC can be used to transfer a block of 128 bytes of data by

means of software activation. The transfer source address is H'1000 and the destination address is

H'2000. The vector number is H'60, so the vector address is H'04C0.

[1] Set MRA to incrementing source address (SM1 = 1, SM0 = 0), incrementing destination

address (DM1 = 1, DM0 = 0), block transfer mode (MD1 = 1, MD0 = 0), and byte size (Sz =

0). The DTS bit can have any value. Set MRB for one block transfer by one interrupt (CHNE =

0). Set the transfer source address (H'1000) in SAR, the destination address (H'2000) in DAR,

and 128 (H'8080) in CRA. Set 1 (H'0001) in CRB.

[2] Set the start address of the register information at the DTC vector address (H'04C0).

[3] Check that the SWDTE bit in DTVECR is 0. Check that there is currently no transfer activated

by software.

[4] Write 1 to the SWDTE bit and the vector number (H'60) to DTVECR. The write data is H'E0.

[5] Read DTVECR again and check that it is set to the vector number (H'60). If it is not, this

indicates that the write failed. This is presumably because an interrupt occurred between steps

3 and 4 and led to a different software activation. To activate this transfer, go back to step 3.

[6] If the write was successful, the DTC is activated and a block of 128 bytes of data is transferred.

[7] After the transfer, an SWDTEND interrupt occurs. The interrupt handling routine should clear

the SWDTE bit to 0 and perform other wrap-up processing.

H8S2245 データシート(PDF) 247 Page - Renesas Technology Corp