| データシートサーチシステム |
|
CS4294/CS4298 データシート(PDF) 62 Page - Cirrus Logic |
|
|
|||||||||||||||||||||||||||||
CS4294/CS4298 データシート(HTML) 62 Page - Cirrus Logic |
|
62 / 66 page ![]() CS4202 62 DS549PP2 13. PARAMETER AND TERM DEFINITIONS AC ’97 Specification Refers to the Audio Codec ’97 Component Specification Ver 2.2 published by the Intel® Corporation [6]. AC ’97 Controller or Controller Refers to the control chip which interfaces to the audio codec AC-link. This has been also called DC ’97 for Digital Controller ’97 [6]. AC ’97 Registers or Codec Registers Refers to the 64-field register map defined in the AC ’97 Specification. ADC Refers to a single Analog-to-Digital converter in the CS4202. “ADCs” refers to the stereo pair of Analog-to-Digital converters. The CS4202 ADCs have 18-bit resolution. Codec Refers to the chip containing the ADCs, DACs, and analog mixer. In this data sheet, the codec is the CS4202. DAC Refers to a single Digital-to-Analog converter in the CS4202. “DACs” refers to the stereo pair of Digital-to-Analog converters. The CS4202 DACs have 20-bit resolution. dB FS A dB FS is defined as dB relative to full-scale. The “A” indicates an A weighting filter was used. Differential Nonlinearity The worst case deviation from the ideal code width. Units in LSB. Dynamic Range (DR) DR is the ratio of the RMS full-scale signal level divided by the RMS sum of the noise floor, in the presence of a signal, available at any instant in time (no change in gain settings between measurements). Measured over a 20 Hz to 20 kHz bandwidth with units in dB FS A. FFT Fast Fourier Transform. Frequency Response (FR) FR is the deviation in signal level verses frequency. The 0 dB reference point is 1 kHz. The amplitude corner, Ac, lists the maximum deviation in amplitude above and below the 1 kHz reference point. The listed minimum and maximum frequencies are guaranteed to be within the Ac from minimum frequency to maximum frequency inclusive. Fs Sampling Frequency. Interchannel Gain Mismatch For the ADCs, the difference in input voltage to get an equal code on both channels. For the DACs, the difference in output voltages for each channel when both channels are fed the same code. Units are in dB. |
|
リンク URL |
| ALLDATASHEETはお客様のビジネスに役立ちますか? [ DONATE ] |
Alldatasheetは | 広告 | お問い合わせ | プライバシーポリシー | データシートへのリンク | リンク交換 | メーカーリスト All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |