GENNUM CORPORATION

522 - 75 - 05

3 of 18

SS[2:0] Input Voltage

HIGH, Manual Mode

2

-

-

V

3

LOW, Manual Mode

-

-

0.8

CLK_EN Source Current

-

26

55

µA

1

NOTES

1. TYPICAL - measured on EB9025A board.

3. LOCK is an open collector output and requires an external pull-up

resistor.

4. Pins SS[2:0] are outputs in AUTO mode and inputs in MANUAL mode.

5. If OEM_TEST is permanently enabled, operating temperature range is

limited from 0°C to 60°C inclusive.

TEST LEVELS

1. Production test at room temperature and nominal supply

voltage with guardbands for supply and temperature

ranges.

2. Production test at room temperature and nominal supply

voltage with guardbands for supply and temperature

ranges using correlated test.

3. Production test at room temperature and nominal supply

voltage.

4. QA sample test.

5. Calculated result based on Level 1,2, or 3.

6. Not tested. Guaranteed by design simulations.

7. Not tested. Based on characterization of nominal parts.

8. Not tested. Based on existing design/characterization

data of similar product.

9. Indirect test.

AC ELECTRICAL CHARACTERISTICS

PARAMETER

CONDITIONS

MIN

TYPICAL

1

MAX

UNITS

NOTES

TEST

LEVEL

Serial Data Rate

SDI

143

-

540

Mb/s

3

Maximum Equalizer Gain

@ 200MHz

-

40

-

dB

6

Additive Jitter

[Pseudorandom (2

270Mb/s, 300m

(Belden 8281)

-

300

-

ps p-p

2, 8

9

540Mb/s, 100m

(Belden 8281)

-

275

-

Intrinsic Jitter

[Pseudorandom (2

270Mb/s

-

185

see Figure 12

ps p-p

2, 7

4

540Mb/s

-

164

Intrinsic Jitter

[Pathological (SDI checkfield)]

270Mb/s

-

462

see Figure 13

ps p-p

2, 7

3

360Mb/s

-

308

540Mb/s

-

260

Input Jitter Tolerance

270Mb/s

0.40

0.56

-

UI p-p

3, 7

9

540Mb/s

0.32

0.43

-

Lock Time -

Synchronous Switch

-

1

-

µs

4

7

-

1

-

ms

-

4

-

ms

Lock Time -

Asynchronous Switch

Loop Bandwidth

= 6MHz @ 540Mb/s

-10

-

ms

5

7

DC ELECTRICAL CHARACTERISTICS (Continued)

PARAMETER

CONDITION

MIN

TYPICAL

1

MAX

UNITS

NOTES

TEST

LEVEL