KTPFPGMEVMEUG datasheet(4/48 Pages) FREESCALE

4 / 48 page

KTPFPGMEVMEUG, Rev. 2.0

Freescale Semiconductor

Introduction

Freescale recommends the KITPFPGMEVME development tool, also known as the PF Programmer, for

configuring and programming the PF0100 Power Management Integrated Circuit. This PMIC is designed primarily

for use with Freescale's i.MX6 series of application processors.

This document describes the specifications of the graphical user interface (GUI) for the PF0100 device. The

primary features of this GUI are:

1. Read/write access to PF0100 registers

2. Intuitive control for programming the PF0100’s start up configuration

3. Script to enable the 8V Boost and 3.3V LDO on the PF Programmer

4. Script to enable the configuration macros for fuse prototyping and fuse programming

5. Save or recall user defined configuration file

Note: This document provides updated information on the installation and use of the current PF0100 EVK Control

GUI, revision 3.0.0.20. Some discrepancies may be found if using an earlier version of the GUI. To learn about the

version of the GUI you are using, please refer to section “Graphical User Interface Description”.

Software and Hardware Requirements

The KITPFPGMEVME Programmer is a development tool designed to provide easy configuration of the PF Series

devices and to facilitate prototyping and programming the device's (OTP) one-time programmable fuses. The

programmer kit comes with a PF series programmer, a flat ribbon cable (8-conductor) and a mini-USB cable, as

shown in Figure 2.

Figure 2. KITPFPGMEVME PF Series Programmer

KTPFPGMEVMEUG データシート(PDF) 4 Page - Freescale Semiconductor, Inc