AD7680 datasheet(18/28 Pages) AD

18 / 28 page

AD7688

Rev. A | Page 18 of 28

CS MODE 3-WIRE WITH BUSY INDICATOR

This mode is usually used when a single AD7688 is connected

to an SPI-compatible digital host having an interrupt input.

The connection diagram is shown in Figure 36 and the

corresponding timing is given in Figure 37.

With SDI tied to VIO, a rising edge on CNV initiates a

conversion, selects the CS mode, and forces SDO to high

impedance. SDO is maintained in high impedance until the

completion of the conversion irrespective of the state of CNV.

Prior to the minimum conversion time, CNV could be used to

select other SPI devices, such as analog multiplexers, but CNV

must be returned low before the minimum conversion time and

held low until the maximum conversion time to guarantee the

generation of the BUSY signal indicator. When the conversion

is complete, SDO goes from high impedance to low. With a

pull-up on the SDO line, this transition can be used as an

interrupt signal to initiate the data reading controlled by the

digital host. The AD7688 then enters the acquisition phase and

powers down. The data bits are then clocked out, MSB first, by

subsequent SCK falling edges. The data is valid on both SCK

edges. Although the rising edge can be used to capture the data,

a digital host using the SCK falling edge allows a faster reading

rate provided it has an acceptable hold time. After the optional

17th SCK falling edge, or when CNV goes high, whichever is

earlier, SDO returns to high impedance.

If multiple AD7688s are selected at the same time, the SDO

output pin handles this contention without damage or induced

latch-up. Meanwhile, it is recommended to keep this contention

as short as possible to limit extra power dissipation.

DATA IN

IRQ

CLK

CONVERT

VIO

DIGITAL HOST

47k

CNV

SCK

SDO

SDI

VIO

AD7688

Figure 36. CS Mode 3-Wire with BUSY Indicator

Connection Diagram (SDI High)

SDO

D15

D14

tDIS

SCK

tSCK

tSCKL

tSCKH

tHSDO

tDSDO

CNV

CONVERSION

ACQUISITION

tCONV

tCYC

tCNVH

tACQ

ACQUISITION

SDI = 1

Figure 37. CS Mode 3-Wire with BUSY Indicator Serial Interface Timing (SDI High)

AD7680 データシート(PDF) 18 Page - Analog Devices

AD7680 データシート(HTML) 18 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

データシートダウンロード