AD7680 datasheet(20/28 Pages) AD

20 / 28 page

AD7688

Rev. A | Page 20 of 28

CS MODE 4-WIRE WITH BUSY INDICATOR

This mode is usually used when a single AD7688 is connected

to an SPI-compatible digital host, which has an interrupt input,

and it is desired to keep CNV, which is used to sample the

analog input, independent of the signal used to select the data

reading. This requirement is particularly important in

applications where low jitter on CNV is desired.

The connection diagram is shown in Figure 40 and the

corresponding timing is given in Figure 41.

With SDI high, a rising edge on CNV initiates a conversion,

selects the CS mode, and forces SDO to high impedance. In this

mode, CNV must be held high during the conversion phase and

the subsequent data readback (if SDI and CNV are low, SDO is

driven low). Prior to the minimum conversion time, SDI could

be used to select other SPI devices, such as analog multiplexers,

but SDI must be returned low before the minimum conversion

time and held low until the maximum conversion time to

guarantee the generation of the BUSY signal indicator. When

the conversion is complete, SDO goes from high impedance to

low. With a pull-up on the SDO line, this transition can be used

as an interrupt signal to initiate the data readback controlled by

the digital host. The AD7688 then enters the acquisition phase

and powers down. The data bits are then clocked out, MSB first,

by subsequent SCK falling edges. The data is valid on both SCK

edges. Although the rising edge can be used to capture the data,

a digital host using the SCK falling edge allows a faster reading

rate provided it has an acceptable hold time. After the optional

17th SCK falling edge, or SDI going high, whichever is earlier,

the SDO returns to high impedance.

DATA IN

IRQ

CLK

CONVERT

CS1

VIO

DIGITAL HOST

47k

CNV

SCK

SDO

SDI

AD7688

Figure 40. CS Mode 4-Wire with BUSY Indicator Connection Diagram

SDO

D15

D14

tDIS

SCK

tSCK

tSCKL

tSCKH

tHSDO

tDSDO

tEN

CONVERSION

ACQUISITION

tCONV

tCYC

tACQ

ACQUISITION

SDI

CNV

tSSDICNV

tHSDICNV

Figure 41. CS Mode 4-Wire with BUSY Indicator Serial Interface Timing

AD7680 データシート(PDF) 20 Page - Analog Devices

AD7680 データシート(HTML) 20 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

データシートダウンロード