AN983 datasheet(9/91 Pages) ETC

9 / 91 page

AN983B

PCI/miPCI Fast Ethernet Controller with integrated PHY

1. GENERAL DESCRIPTIONS

The AN983B is a high performance PCI Fast Ethernet controller with integrated physical layer

interface for 10BASE-T and 100BASE-TX application.

The AN983B was designed with advanced CMOS technology to provide glueless 32-bit bus

master interface for PCI, boot ROM interface, CSMA/CD protocol for Fast Ethernet, as well as

the physical media interface for 100BASE-TX of IEEE802.3u and 10BASE-T of IEEE802.3. The

auto-negotiation function is also supported for speed and duplex detection.

The AN983B can be programmed as MAC-only controller.

In this mode, it provides the

standard MII interface to link to an external PHY.

With this mode, it can be connected to the

HomePNA PHY to support the HomePNA networking solution or Homeplug Phy(Power-line

solution) to support Homeplug networking solution..

The AN983B provides both half-duplex and full-duplex operation, as well as support for

full-duplex flow control.

It provides long FIFO buffers for transmission and receiving, and early interrupt mechanism to

enhance performance.

The AN983B also supports ACPI and PCI compliant power management function and Magic

Packet wake-up event.

ADMtek Inc.

www.admtek.com.tw

Rev. 1.8

AN983 データシート(PDF) 9 Page - List of Unclassifed Manufacturers