Table 2. Recommended test accessories

Model number

Description

Add-in card testing

PCI-SIG Compliance Base Board (order from

www.pcisig.com/specifications/ordering_information)

15442A

Two SMA cables

One PC power supply

One power supply load for regulation

1810-0118

Six 50 Ω terminators

System motherboard testing

PCI-SIG Compliance Base Board (order from

www.pcisig.com/specifications/ordering_information)

15442A

Two SMA cables

1134A or 1169A

InfiniiMax probe with socketed (E2678A) probe adapter

1250-1741

Two right angle SMA adapters (f - m)

1810-0118

Six 50 Ω terminators

Semiconductor device testing

Customer supplied custom test fixtures with SMAs

15442A

Two SMA cables

1169A

One InfiniiMax probe with differential solder connection (E2677A)

Optional (for all types of testing)

11667B

Power splitter, DC to 26.5 GHz, 3.5 mm (f) connectors

11636B

Power divider, DC to 26.5 GHz, 3.5 mm (f) connectors

1250-1159

Three SMA (m - m) adapters

8493B

Coaxial attenuator (3, 6, 10, 20 or 30 dB), DC to 18 GHz, SMA connector

Matched cable pair, two 90 cm (36 inch) SMA (m - m) cables propagation delay within 25 ps

1810-0118

SMA (m) 50 Ω termination

Recommended Test Accessories

To complete your test setup, Keysight provides a wide range of cables, adapters, terminations, etc.

Note: While the PCI-SIG does supply Gen2 test fixtures for motherboard and add-in card testing, you will need to obtain SMP cables,

adapters and terminators from a vendor of your choice as the SIG does not supply them.