System introduction

UM1502

6/23

Doc ID 022625 Rev 1

1.3.3

Installation

The installation of the STEVAL-MKI111V1 is described in this document.

The components must be protected against excessive strain. In particular, no components

should be bent, or isolating distances altered during transportation, handling or use. No

contact must be made with electronic components and contacts.

The STEVAL-MKI111V1 contains electrostatically sensitive components, which may be

damaged if used improperly. To avoid risk of injury, ensure that electrical components are

not mechanically damaged.

1.3.4

Electrical connection

Applicable accident prevention rules must be followed when working from the mains power

supply. The electrical installation must be completed in accordance with the appropriate

requirements (e.g. cross-section areas of conductors, fusing and PE connections).

1.3.5

Board operation

A system architecture which supplies power to the demonstration board must be equipped

with additional control and protective devices, in accordance with the applicable safety

requirements (e.g. compliance of equipment and accident prevention rules).