ATSAMB11XR datasheet(76/87 Pages) MICROCHIP

76 / 87 page

16.

Regulatory Approval

Regulatory approvals received:

ATSAMB11-ZR210CA

•

United States/FCC ID: 2ADHKBZR

•

Canada/ISED

–

IC: 20266-SAMB11ZR

–

HVIN: ATSAMB11-ZR210CA

•

Europe - CE

16.1

United States

The ATSAMB11-ZR210CA module has received Federal Communications Commission (FCC) CFR47

Telecommunications, Part 15 Subpart C “Intentional Radiators” single-modular approval in accordance

with Part 15.212 Modular Transmitter approval. Single-modular transmitter approval is defined as a

complete RF transmission sub-assembly, designed to be incorporated into another device, that must

demonstrate compliance with FCC rules and policies independent of any host. A transmitter with a

modular grant can be installed in different end-use products (referred to as a host, host product, or host

device) by the grantee or other equipment manufacturer, then the host product may not require additional

testing or equipment authorization for the transmitter function provided by that specific module or limited

module device.

The user must comply with all of the instructions provided by the Grantee, which indicate installation

and/or operating conditions necessary for compliance.

A host product itself is required to comply with all other applicable FCC equipment authorization

regulations, requirements, and equipment functions that are not associated with the transmitter module

portion. For example, compliance must be demonstrated: to regulations for other transmitter components

within a host product; to requirements for unintentional radiators (Part 15 Subpart B), such as digital

devices, computer peripherals, radio receivers, etc.; and to additional authorization requirements for the

non-transmitter functions on the transmitter module (i.e., Verification or Declaration of Conformity) as

appropriate (e.g., Bluetooth and Wi-Fi transmitter modules may also contain digital logic functions).

16.1.1

Labeling And User Information Requirements

Due to the limited module size of ATSAMB11-ZR210CA (7.503 mm x10.541 mm), FCC identifier is

displayed only in the datasheet and packaging box label. FCC identifier cannot be displayed on the

module label. When the module is installed inside another device, then the outside of the finished product

into which the module is installed must display a label referring to the enclosed module. This exterior

label can use wording as follows:

For the ATSAMB11-ZR210CA:

Contains Transmitter Module FCC ID: 2ADHKBZR

Contains FCC ID: 2ADHKBZR

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation

ATSAMB11XR/ZR

Datasheet Preliminary

DS70005342A-page 76

ATSAMB11XR データシート(PDF) 76 Page - Microchip Technology

ATSAMB11XR データシート(HTML) 76 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87

データシートダウンロード