HD64F2149YV datasheet(129/1075 Pages) RENESAS

129 / 1075 page

Section 5 Interrupt Controller

Rev. 3.00 Jan 18, 2006 page 101 of 1044

REJ09B0280-0300

Section 5 Interrupt Controller

5.1

Overview

5.1.1

Features

The MCU control interrupts by means of an interrupt controller. The interrupt controller has the

following features:

• Two interrupt control modes

 Either of two interrupt control modes can be set by means of the INTM1 and INTM0 bits

in the system control register (SYSCR).

• Priorities settable with ICR

 An interrupt control register (ICR) is provided for setting interrupt priorities. Three priority

levels can be set for each module for all interrupts except NMI and address break.

• Independent vector addresses

 All interrupt sources are assigned independent vector addresses, making it unnecessary for

the source to be identified in the interrupt handling routine.

• Thirty-one external interrupt pins (nine external sources)

 NMI is the highest-priority interrupt, and is accepted at all times. A rising or falling edge at

the NMI pin can be selected for the NMI interrupt.

 Falling edge, rising edge, or both edge detection, or level sensing, at pins IRQ7 to IRQ0

can be selected for interrupts IRQ7 to IRQ0.

 The IRQ6 interrupt is shared by the interrupt from the IRQ6 pin and eight external interrupt

inputs (

KIN7 to KIN0), and the IRQ7 interrupt is shared by the interrupt from the IRQ7 pin

and sixteen external interrupt inputs (

KIN15 to KIN8 and WUE7 to WUE0). KIN15 to

KIN0 and WUE7 to WUE0 can be masked individually by the user program.

• DTC control

 DTC activation is controlled by means of interrupts.

HD64F2149YV データシート(PDF) 129 Page - Renesas Technology Corp