UM1811 datasheet(35/52 Pages) STMICROELECTRONICS

35 / 52 page

DocID026814 Rev 1

35/52

UM1811

ADP menu

Figure 23. Effect of show routing table command

7.5

ADP information base attributes description

Here is a brief description for all the attributes of the ADP information base.

Table 8. ADP G.9903 information base attributes52

Standard G.9903 ADP information base attributes

adpSecurityLevel

The minimum security level to be used for incoming and outgoing adaptation

frames

adpPrefixTable

Contains the list of prefixes defined on this PAN. Note that it is assumed that the

link local IPv6 address exists independently and is not affected by the prefixes

defined in the prefix table

adpBroadcastLogTableEntryTTL Maximum time to live of a adpBroadcastLogTable entry (in seconds)

adpMetricType

A metric type to be used for routing purposes

adpNumDiscoveryAttempts

The number of discovery attempts

adpDiscoveryAttemptsWaitTime

Allows programming the maximum wait time between invocation of two

consecutive network discovery primitives (in seconds)

adpContextInformationTable

Contains the context information associated to each CID extension field

adpCoordShortAddress

Defines the short address of the coordinator

adpRLCEnabled

Enables the sending of RLCREQ frame by the device

adpAddRevLinkCost

It represents an additional cost to take into account a possible asymmetry in the

link

UM1811 データシート(PDF) 35 Page - STMicroelectronics