STM32F413RHT6 datasheet(78/207 Pages) STMICROELECTRONICS

部品番号	STM32F413RHT6

部品情報	ARM-Cortex-M4 32b MCUFPU, 125 DMIPS, up to 1.5MB Flash, 320KB RAM, USB OTG FS, 1 ADC, 2 DACs, 2 DFSDMs

PDF	207 Pages

Scroll/Zoom	100%

メーカー	STMICROELECTRONICS [STMicroelectronics]

ホームページ	http://www.st.com

Logo

78 / 207 page

Electrical characteristics

STM32F413xG/H

78/207

DocID029162 Rev 2

6.1.6

Power supply scheme

Figure 21. Power supply scheme

1. To connect PDR_ON pin, refer to Section: Power supply supervisor.

2. The 4.7 µF ceramic capacitor must be connected to one of the VDD pin.

3. VCAP_2 pad is only available on 100-pin and 144-pin packages.

4. VDDA=VDD and VSSA=VSS.

5. VDDUSB is a dedicated independent USB power supply for the on-chip full-speed OTG PHY module and

associated DP/DM GPIOs. VDDUSB value does not depend on the VDD and VDDA values, but it must be the

last supply to be provided and the first to disappear.

Caution:

Each power supply pair (for example VDD/VSS, VDDA/VSSA) must be decoupled with filtering

ceramic capacitors as shown above. These capacitors must be placed as close as possible

to, or below, the appropriate pins on the underside of the PCB to ensure good operation of

the device. It is not recommended to remove filtering capacitors to reduce PCB size or cost.

This might cause incorrect operation of the device.

STM32F413RHT6 データシート(PDF) 78 Page - STMicroelectronics