ST95HF datasheet(52/93 Pages) STMICROELECTRONICS

52 / 93 page

Electrical characteristics

ST95HF

52/93

DocID025630 Rev 4

Electrical characteristics

6.1

Absolute maximum ratings

Note:

Stresses listed above may cause permanent damage to the device. This is a stress rating

only and functional operation of the device at these or any other conditions above those

indicated in the operational sections of the specification is not implied.

Exposure to absolute maximum rating conditions for extended periods may affect device

reliability.

Table 44. Absolute maximum ratings

Symbol

Parameter

Value

Unit

VPS_Main Supply voltage (1)

–0.3 to 7.0

VPS_TX

Supply voltage (RF drivers)

–0.3 to 7.0

VIO

Input or output voltage relative to ground

–0.3 to VPS_Main +0.3

VMaxCarrier Maximum input voltage (pins RX1 and RX2)

±14.0

Ambient operating temperature

–25 to +85

°C

Ambient operating temperature (RF mode)

–25 to +85

TSTG

Storage temperature (Please also refer to package specification).

–65 to +150

°C

TLEAD

Lead temperature during soldering

See note(2)

°C

VESD

Electrostatic discharge voltage according to JESD22-A114,

Human Body Model

2000

PTOT (3)

Total power dissipation per package

1. To properly reset the device, VPS_Main must be tied to 0V before executing the start-up sequence.

2. Compliant with JEDEC standard J-STD-020D (for small-body, Sn-Pb or Pb assembly), the ST ECOPACK® 7191395

specification, and the European directive on Restrictions on Hazardous Substances (RoHS directive 2011/65/EU of July

2011).

3. Depending on the thermal resistance of package.

ST95HF データシート(PDF) 52 Page - STMicroelectronics

ST95HF データシート(HTML) 52 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93

データシートダウンロード