STM8S datasheet(65/467 Pages) STMICROELECTRONICS

65 / 467 page

DocID14587 Rev 14

65/467

RM0016

Interrupt controller (ITC)

6.5.2

Nested interrupt management mode

In this mode, interrupts are allowed during interrupt routines. This mode is activated as soon

as an interrupt priority level lower than level 3 is set.

The hardware priority is given in the following order from the lowest to the highest priority,

that is: MAIN, IT4, IT3, IT2, IT1, IT0, and TRAP.

The software priority is configured for each interrupt vector by setting the corresponding

I1_x and I0_x bits of the ITC_SPRx register. I1_x and I0_x bits have the same meaning as

I1 and I0 bits of the CCR register (see Table 10).

Level 0 can not be programmed (I1_x=1, I0_x=0). In this case, the previously stored value is

kept. For example: if previous value is 0xCF, and programmed value equals 64h, the result

is 44h.

The RESET and TRAP vectors have no software priorities. When one is serviced, bits I1

and I0 of the CCR register are both set.

Caution:

If bits I1_x and I0_x are modified while the interrupt x is executed, the device operates as

follows: if the interrupt x is still pending (new interrupt or flag not cleared) and the new

software priority is higher than the previous one, then the interrupt x is re-entered.

Otherwise, the software priority remains unchanged till the next interrupt request (after the

IRET of the interrupt x).

During the execution of an interrupt routine, the HALT, POPCC, RIM, SIM and WFI

instructions change the current software priority till the next IRET instruction or one of the

previously mentioned instructions is issued. See Section 6.7 for the list of dedicated

interrupt instructions.

Figure 16 shows an example of nested interrupt management mode.

Warning:

A stack overflow may occur without notifying the software of

the failure.

Table 10. Vector address map versus software priority bits

Vector address

ITC_SPRx bits

0x00 8008h

I1_0 and I0_0 bits(1)

1. ITC_SPRx register bits corresponding to the TLI can be read and written. However they are not significant

in the interrupt process management.

0x00 800Ch

I1_1 and I0_1 bits

...

0x00 807Ch

I1_29 and I0_29 bits

STM8S データシート(PDF) 65 Page - STMicroelectronics

STM8S データシート(HTML) 65 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

データシートダウンロード