STM8S datasheet(155/467 Pages) STMICROELECTRONICS

155 / 467 page

DocID14587 Rev 14

155/467

RM0016

16-bit advanced control timer (TIM1)

261

17.4.5

Trigger synchronization

There are four trigger inputs (refer to Table 35: Glossary of internal timer signals on

page 136):

•

ETR

•

TI1

•

TI2

•

TRGO from TIM5/TIM6

The TIM1 timer can be synchronized with an external trigger in three modes: Trigger

standard mode, trigger reset mode and trigger gated mode.

Trigger standard mode

The counter can start in response to an event on a selected input.

Procedure

Use the following procedure to start the up-counter in response, for example, to a rising

edge on the TI2 input:

Configure channel 2 to detect rising edges on TI2. As no filter is required in this

example, configure an input filter duration of 0 (IC2F = 0000). The capture prescaler is

not used for triggering and does not need to be configured. The CC2S bits select the

input capture source and do not need to be configured either. Write CC2P = 0 in the

TIM1_CCER1 register to select rising edge polarity.

Configure the timer in trigger mode by writing SMS = 110 in the TIM1_SMCR register.

Select TI2 as the input source by writing TS = 110 in the TIM1_SMCR register.

When a rising edge occurs on TI2, the counter starts counting on the internal clock and the

TIF flag is set.

The delay between the rising edge on TI2 and the actual reset of the counter is due to the

resynchronization circuit on TI2 input.

Figure 49. Control circuit in trigger mode

STM8S データシート(PDF) 155 Page - STMicroelectronics

STM8S データシート(HTML) 155 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

データシートダウンロード