STM8L151C2 datasheet(90/123 Pages) STMICROELECTRONICS

90 / 123 page

Electrical parameters

STM8L151x2, STM8L151x3

90/123

DS7204 Rev 11

I2C - Inter IC control interface

Subject to general operating conditions for VDD, fSYSCLK, and TA unless otherwise specified.

The STM8L I2C interface (I2C1) meets the requirements of the Standard I2C communication

protocol described in the following table with the restriction mentioned below:

Refer to I/O port characteristics for more details on the input/output alternate function

characteristics (SDA and SCL).

Note:

For speeds around 200 kHz, the achieved speed can have a

± 5% tolerance

For other speed ranges, the achieved speed can have a

± 2% tolerance

The above variations depend on the accuracy of the external components used.

Table 43. I2C characteristics

Symbol

Parameter

Standard mode

I2C

Fast mode I2C(1)

fSYSCLK must be at least equal to 8 MHz to achieve max fast I

2C speed (400 kHz).

Unit

Min(2)

Data based on standard I2C protocol requirement, not tested in production.

Max (2)

Min (2)

Max (2)

tw(SCLL)

SCL clock low time

4.7

1.3

μs

tw(SCLH)

SCL clock high time

4.0

0.6

tsu(SDA)

SDA setup time

250

100

th(SDA)

SDA data hold time

900

tr(SDA)

tr(SCL)

SDA and SCL rise time

1000

300

tf(SDA)

tf(SCL)

SDA and SCL fall time

300

th(STA)

START condition hold time

4.0

0.6

μs

tsu(STA)

Repeated START condition setup

time

4.7

0.6

tsu(STO)

STOP condition setup time

4.0

0.6

μs

tw(STO:STA)

STOP to START condition time (bus

free)

4.7

1.3

μs

Capacitive load for each bus line

400

STM8L151C2 データシート(PDF) 90 Page - STMicroelectronics

STM8L151C2 データシート(HTML) 90 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

データシートダウンロード