 |
データシートサーチシステム |
|
|
データシートサーチシステム |
|
L9908 データシート(PDF) 36 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
L9908 データシート(HTML) 36 Page - STMicroelectronics |
|
|
36 / 153 page  Figure 15. Shutdown fault - Transient fault timing diagram Figure 16. Shutdown fault - Permanent fault timing diagram Table 30. EN_BR minimum t_off time Symbol Parameter Min Typ Max Unit Notes EN_BR_tclear Minimum time interval to assert low value on EN_BR 2.5 - - μs Not subject to production test Note: All parameters are guaranteed, and tested, in the voltage ranges specified above in Table 5 unless otherwise specified. Where not specified the parametrical operating range equals the functional operating range. Note: • In case of BIST_STATUS=11 (BIST check failure) the device sent in SAFE_OFF Mode, re-engage procedure can be performed only by issuing a SW_REST command. • In case of WDT_OVF_fail = 1 or WDT_DATA_fail = 1 (WDT failure) the device sent in SAFE_OFF Mode, re-engage procedure can be performed only by issuing a WDT_RST or a SW_REST command. 5.6.2.2 Auto-retry faults When an auto-retry fault is detected the related SPI flag is set to ‘1’, the IC ERR bits in SPI FRAME are set to ‘11’ and the FS_FLAG is asserted low. L9908 Fault Handling Management (FHM) DS13546 - Rev 3 page 36/153 |
|
リンク URL |
| ALLDATASHEETはお客様のビジネスに役立ちますか？ [ DONATE ] |
Alldatasheetは | 広告 | お問い合わせ | プライバシーポリシー | データシートへのリンク | リンク交換 | メーカーリスト All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Japanese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
