ST10R172L datasheet(34/68 Pages) STMICROELECTRONICS

34 / 68 page

34/68

ST10R172L - ELECTRICAL CHARACTERISTICS

PORT0 configuration current3

IP0H

–-4

µAV

IN = VIHmin

IP0L

-50

–

µAV

IN = VILmax

RPD pulldown current2

IRPD

100

500

µAV

OUT = VDD

XTAL1 input current

IIL

–

±20

µA

0 V <

VIN < VDD

Pin capacitance6)

(digital inputs/outputs)

CIO

–

f = 1 MHz

TA = 25 °C

Power supply current

ICC

–15 +

2.5 * fCPU

fCPU in [MHz]

7))

Idle mode supply current

IID

–10 +

0.9 * fCPU

RSTIN =

VIH1

fCPU in [MHz]

Power-down mode supply current I

–200

µA

VDD = 3.6 V

1) This specification is not valid for outputs which are switched to open drain mode. In this case

the respective output will float and the resulting voltage comes from the external circuitry.

2) This specification is only valid during reset, or interruptible power-down mode, after recep-

tion of an external interrupt signal that will wake up the CPU.

3) This specification is only valid during reset, hold or adapt-mode. Port 6 pins are only affected

if they are used for CS output and the open drain function is not enabled.

4) The maximum current may be drawn while the signal line remains inactive.

5) The minimum current must be drawn in order to drive the signal line active.

6) Not 100% tested, guaranteed by design characterization.

7) Supply current is a function of operating frequency as illustrated in Figure 7 on page 35.

This parameter is tested at VDDmax and 50 MHz CPU clock with all outputs disconnected

and all inputs at VIL or VIH with an infinite execution of NOP instruction fetched from external

memory (16-bit demux bus mode, no waitstates, no memory tri-state waitstates, normal

ALE).

8) Typical value at 25°C = 20µA.

9) This parameter is tested including leakage currents. All inputs (including pins configured as

inputs) at 0 V to 0.1 V or at VDD – 0.1 V to VDD, VREF = 0 V, all outputs (including pins con-

figured as outputs) disconnected.

Parameter

Symbol

Limit Values

Unit

Test Condition

min.

max.

Table 11 DC characteristics

ST10R172L データシート(PDF) 34 Page - STMicroelectronics

ST10R172L データシート(HTML) 34 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68

データシートダウンロード