5000 datasheet(18/104 Pages) INTEL

18 / 104 page

Electrical Specifications

Dual-Core Intel® Xeon® Processor 5000 Series Datasheet

2.4.2

Phase Lock Loop (PLL) and Filter

VCCA and VCCIOPLL are power sources required by the PLL clock generators on the Dual-

Core Intel Xeon Processor 5000 series. Since these PLLs are analog in nature, they

require low noise power supplies for minimum jitter. Jitter is detrimental to the system:

it degrades external I/O timings as well as internal core timings (that is, maximum

frequency). To prevent this degradation, these supplies must be low pass filtered from

VTT.

The AC low-pass requirements are as follows:

• < 0.2 dB gain in pass band

• < 0.5 dB attenuation in pass band < 1 Hz

• > 34 dB attenuation from 1 MHz to 66 MHz

• > 28 dB attenuation from 66 MHz to core frequency

The filter requirements are illustrated in Figure 2-1. For recommendations on

implementing the filter, refer to the appropriate platform design guidelines.

Notes:

Diagram not to scale.

No specifications for frequencies beyond fcore (core frequency).

fpeak, if existent, should be less than 0.05 MHz.

fcore represents the maximum core frequency supported by the platform.

Figure 2-1. Phase Lock Loop (PLL) Filter Requirements

CS00141

0 dB

-28 dB

-34 dB

0.2 dB

forbidden

zone

-0.5 dB

forbidden

zone

1 MHz

66 MHz

fcore

fpeak

1 Hz

passband

high frequency

band

5000 データシート(PDF) 18 Page - Intel Corporation

5000 データシート(HTML) 18 Page - Intel Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

データシートダウンロード