STM32L443CC datasheet(47/207 Pages) STMICROELECTRONICS

47 / 207 page

DocID028739 Rev 2

47/207

STM32L443CC STM32L443RC STM32L443VC

Functional overview

3.31

Single wire protocol master interface (SWPMI)

The Single wire protocol master interface (SWPMI) is the master interface corresponding to

the Contactless Frontend (CLF) defined in the ETSI TS 102 613 technical specification. The

main features are:

•

full-duplex communication mode

•

automatic SWP bus state management (active, suspend, resume)

•

configurable bitrate up to 2 Mbit/s

•

automatic SOF, EOF and CRC handling

SWPMI can be served by the DMA controller.

3.32

Controller area network (CAN)

The CAN is compliant with specifications 2.0A and B (active) with a bit rate up to 1 Mbit/s. It

can receive and transmit standard frames with 11-bit identifiers as well as extended frames

with 29-bit identifiers. It has three transmit mailboxes, two receive FIFOs with 3 stages and

14 scalable filter banks.

The CAN peripheral supports:

•

Supports CAN protocol version 2.0 A, B Active

•

Bit rates up to 1 Mbit/s

Table 11. SAI implementation

SAI features

Support(1)

1. X: supported

I2S, LSB or MSB-justified, PCM/DSP, TDM, AC’97

Mute mode

Stereo/Mono audio frame capability.

16 slots

Data size configurable: 8-, 10-, 16-, 20-, 24-, 32-bit

FIFO Size

X (8 Word)

SPDIF

STM32L443CC データシート(PDF) 47 Page - STMicroelectronics

STM32L443CC データシート(HTML) 47 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

データシートダウンロード