STM8S datasheet(401/467 Pages) STMICROELECTRONICS

401 / 467 page

DocID14587 Rev 14

401/467

RM0016

Controller area network (beCAN)

427

23.11

beCAN registers

23.11.1

CAN master control register (CAN_MCR)

Address offset: 0x00

Reset value: 0x02

654

3210

TTCM

ABOM

AWUM

NART

RFLM

TXFP

SLEEP

INRQ

Bit 7 TTCM Time Triggered Communication Mode

0: Time Triggered Communication mode disabled.

1: Time Triggered Communication mode enabled

Note: For more information on Time Triggered Communication mode, please refer to Section 23.4.4:

Time triggered communication mode.

Bit 6 ABOM Automatic Bus-Off Management

This bit controls the behavior of the CAN hardware on leaving the Bus-Off state.

0: The Bus-Off state is exited on software request.

Refer to Section 23.6.5: Error management, Bus-Off recovery.

1: The Bus-Off state is exited automatically by hardware once 128 x 11 recessive bits have been

monitored.

Note: For detailed information on the Bus-Off state please refer to Section 23.6.5: Error

management.

Bit 5 AWUM Automatic wakeup Mode

This bit controls the behavior of the CAN hardware when a message is received in Sleep mode.

0: The sleep mode is exited on software request by clearing the SLEEP bit in the CAN_MCR

1: The sleep mode is exited automatically by hardware when a CAN message is detected. In this

case, the SLEEP bit of the CAN_MCR register and the SLAK bit of the CAN_MSR register are

cleared by hardware, while the WKUI bit of the CAN_MSR register is set. If the CAN bus is active

when the Sleep automatic wakeup request occurs,it does not enter Sleep mode.

The AWUM and the SLEEP bits must be set simultaneously.

Bit 4 NART No Automatic Retransmission

0: The CAN hardware will automatically retransmit the message until it has been successfully

transmitted according to the CAN standard.

1: A message will be transmitted only once, independently of the transmission result (successful,

error or arbitration lost).

Bit 3 RFLM Receive FIFO Locked Mode

0: Receive FIFO not locked on overrun. Once a receive FIFO is full the next incoming message will

overwrite the previous one.

1: Receive FIFO locked against overrun. Once a receive FIFO is full the next incoming message will

be discarded.

STM8S データシート(PDF) 401 Page - STMicroelectronics

STM8S データシート(HTML) 401 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

データシートダウンロード