SPBT2532C2AT datasheet(24/48 Pages) STMICROELECTRONICS

24 / 48 page

Commands

SPBT2532C2.AT

24/48

Doc ID 16089 Rev 3

The following subsections describe each of these commands in detail, including a

description of behavior, syntax (including possible parameter values), and types of

responses.

Some responses will not be “immediate”. Where applicable, these will be noted and will

include an approximate delay before response.

For commands with optional parameters, all possible forms will be listed under the syntax

subsection.

Error responses are described in Appendix D error responses

C.1

Bond

The Bond command is used to initiate bonding with a specified device. A personal

identification number (PIN) is also required with this command.

C.1.1

Syntax

AT+AB Bond [BD addr] [PIN]

Where

[BD addr] is the BD Address of the remote device with which to bond and [PIN]

is the PIN code to use (up to 16 characters).

C.1.2

Responses

If the request is successfully submitted, the response is:

AT-AB BondPending [BD addr]

If the operation is successful, the response is:

AT-AB BondOk

If the operation fails, the response is:

AT-AB BondFail

Command

abSerial v1.1

Security

√

SmartCableSetup

√

Sniff

√

SPPConnect

√

SPPDisconnect

√

StreamingSerial

√

UpdateInquiryScan

√

UpdatePageScan

√

Version

√

Table 9.

abSerial command summary (continued)

SPBT2532C2AT データシート(PDF) 24 Page - STMicroelectronics

SPBT2532C2AT データシート(HTML) 24 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

データシートダウンロード